|
| |
TM 10-4320-343-14
4.10.4.1.3. Installation. (Refer to Figure 4-7.1)
NOTE
The blockor has left hand threads.
a.
Install blockor (5) in bottom of valve assembly(3).
b.
Position valve assembly(3) on side of engine and secure with flat washers (18), lockwashers (17) and
screws (16).
c.
Secure terminal ring(15) to engine block.
d.
Install temperature switch(9) on side of engine with screw(13), flat washer(14).
e.
Install new connector(11) on wire(12) and secure terminal ring(10) onto starter solenoid.
f.
Install new connectors(7) on wire(8) between temperature switch(9) and valve assembly(3).
g.
Install atomizer(6) into engine manifold and connect tubing(4) to blockor(5).
h.
Install a serviceable can of starting fluid(2) invalve assembly(3) and tighten clamp(1).
Figure 4-7.1. Starting Aid Solenoid Maintenance (Model 350 PAFN).
4-22.2 Change 1
|
