Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: ASSEMBLY. (cont)
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 

TM 10-4320-342-24 3-19.  PUMP AND CLUTCH (600 GPM FUEL PUMP) REPAIR - continued. Refer to Figure 3-18. (26) Use formula P - F - R = S to determine thickness of shim stack number four (1). (a) Install assembled components (2) on shaft (3). (b) Install washer (4) and nut (5) on shaft (3).  Torque nut to 180 lb-in. (c) Measure distance from flange of bearing carrier (6) to top edge of assembled components (2) to determine dimension P. (d) Subtract  dimensions  P  from  dimension  F.    Dimension  F  was  determined  in  para  3-19(.8)(d)  shim  stack number two procedures. (e) Subtract dimension R.  Dimension R is a constant.  R = 0.040. (f) Dimension S is the required thickness of shim stack number four (1) based on the above. (g) Example of formula:  1.690 - 1.610 - 0.040 = 0.040 (27) Select shim stack number four (1). NOTE One or more shims may be used to obtain dimension S above.  Shim is made up of laminated layers and thickness of each layer is 0.002. (a) Select appropriate number of shims (1) to obtain dimension S above. (b) If necessary, peel appropriate number of laminated layers (7) from shim to achieve  dimension S above. (28) Remove nut (5), washer (4) and assembled components (2) from shaft (3). (29) Install shim stack number four (1), assembled components (2), washer (4) and nut (5) on shaft (3).  Torque nut to 171 - 188 inches-pounds. (30) Install assembled components  in  clutch  housing  (8).    Gap  may  be  verified  by  measuring  between  rotor  (9)  and armature (10) thru slot on clutch housing.  Gap should be between 0.035 to 0.045.  If not, adjust last shim stack number four (1). 3-45

Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business