|
| |
TM10-4320-324-14
6-10.
Piston and Connecting Rod Assembly Repair.
This task covers:
a. Disassembly
c. Assembly
b. Cleaning/Inspection
d. Follow-on Maintenance
INITIAL SETUP
Tools
Equipment Condition
Outside micrometer, item 34, section III,
Engine disassembled (para 6-7).
appendix B
Inside micrometer, item 34, section III,
General Safety Instructions
appendix B
Wear personal protective equipment when using
Tool kit, general mechanics, item 35, section III,
cleaning solvent or compressed air for cleaning
appendix B
purposes.
Materials/Parts
Heating of piston to install components may be
Cloth, lint-free, item 3, appendix E
required. Do not touch hot parts without heavy
Solvent, dry cleaning, item 15, appendix E
gloves. Severe burns can result.
a.
Disassembly.
(1) If necessary, remove locating pin (1). Remove
two bearing sleeves (2).
(2) Remove connecting rod (3) and piston (4) as an
assembly.
(3) Remove two circlips (5) and pin (6).
(4) Remove piston (4) from connecting rod (3).
(5) Remove trapezoidal ring (7), taper-faced ring
(8), and oil control ring (9).
(6) Remove sleeve bushing (10).
6-42
|
