|
| |
TM 10-4320-324-14
5-22. Cylinder Head Assembly Replacement (CONT).
NOTE
Place all wide-end of pushrod tube washers facing outward.
Check that upper and lower washers are properly seated when installed.
(3)
Assemble two pushrod tubes (15) four flatwashers (16 and 17), two springs (19), and two caps (18).
WARNING
Use care when installing springs. Springs are under compression tension and can act as projectiles when
released and could cause severe eye injury.
(4)
Install two springs (19) using spring compressor.
(5)
Install two caps (18) and two flatwashers (17).
(6)
Install two flatwashers (16).
(7)
Install two pushrod tubes (15) by inserting spring end in crankcase and cone in cylinder head (13).
5-72
|
