|
| |
TM 10-4320-324-14
4-62.
Wheels and Tires Repair/Replacement (CONT).
c.
Cleaning/Inspection.
(1) Use wire brush to remove all dirt and corrosion from rim.
(2) Inspect wheel for cracks, deep pitting or dents. Replace if significant damage is found.
(3) Measure center tread of tire. If less than 1/16 in. replace tire.
(4) Inspect inner tube for leaks. Replace if leaks are found.
d.
Assembly.
(1) Place wheel (4) on flat surface with valve hole up and install tire (3).
(2) Install inner tube (6) in tire (3) and place valve stem (5) through hole on wheel (4).
(3) Install tire bead (8) on wheel (4).
(4) Inflate tire (3) to 40 psi (275 kPa).
e.
Installation.
(1) Install wheel (4) and tire (3).
(2) Install five nuts (1). Tighten snugly.
(3) Lower frame (7) and remove jack.
(4) Secure leg on side opposite of tire being removed in down position.
(5) Install plug buttons (2) in jack holes.
(6) Tighten five nuts (1) to 40 lb-ft (54 Nm) according to pattern shown.
(7) Remove chocks from wheel.
END OF TASK
4-192
|
