|
| |
TM 10-4320-324-14
c.
Testing. Using wiring diagram, check individual wires for continuity. If continuity is not indicated, check solder
connections, replace all damaged wires and connectors.
d.
Repair. When repairing solder joints, wire connections must be made mechanically sound before they are
soldered. solder alone does not provide sufficient strength to prevent breakage. Surfaces of connections to be
soldered must be clean and bright. Solder shall be a lead-tin solder conforming to Specification QQ-S-571E.
Wires should always be heated to the point at which the solder will melt completely and flow into all parts of the
joint. Excessive buildup or solder globs on the joint should be avoided or removed.
4-117
|
