|
| |
TM 10-4320-316-14
4-21. BAFFLES REPLACEMENT. - Continued.
b. Installation
(1) Install baffle (5) and four screws (8).
(2) Pull the rope T-handle (3) slowly, turning the crankshaft until approximately two feet of pull rope (4) is
exposed.
(3) Grasp the rope (4) firmly and pull the knot (7) in the rope about six inches out of the T-handle (3).
CAUTION
With knot untied do not allow rope to rewind into the starter assembly.
(4) Untie the knot (7).
(5) Slip the T-handle (3) off of the rope (4) and retie the knot.
(6) Feed the rope (4) through the baffle grommet (6).
(7) Install T-handle (3) on the rope (4). Thread enough rope through the T-handle to make knot (5).
(8) Pull rope (4) against the hole in the T-handle (3). Stuff excess rope into the T-handle slot.
(9) Install muffler baffle assembly (2) and three screws (1).
4-36/(4-37 Blank)
|
