|
| |
TM10-4320-31 6-14
5-9.
REGULATOR BRACKET ASSEMBLY REPAIR, ADJUSTMENT, AND REPLACEMENT.
This Task Covers:
a.
Removal
b.
Inspection
c.
Repair
d.
Installation
e.
Adjustment
Initial Setup:
Tools Required
Tool Kit, General Mechanic's (Appendix B, Item 1)
Tachometer (Appendix B, Item 3)
Material’s Required
Diesel Fuel (Appendix E, Item 6)
Equipment Condition
DED pump assembly shut down and cool.
Inlet enclosure removed (see paragraph 4-22).
Control assembly removed (see paragraph 4-15).
a.
Removal. (Refer to Figure 5-3).
(1)
Remove mounting bolts (1 and 2).
(2)
Remove regulator bracket (3) with regulator lever (4) and springs attached.
(3)
Remove regulator spring (5) from the governor lever (6) and regulator lever (4).
(4)
Remove return spring (7) from the governor lever (6) and regulator lever (4).
(5)
Remove regulator coil spring (8).
(6)
Remove regulator lever (4) from regulator bracket (3) by unscrewing lever locking knob (9) and locknut
(10).
(7)
Remove adjusting bolt (11) and nut (12).
(8)
Remove wire (13), bolt (14), and nut (15).
b.
Inspection.
(1)
Clean all parts with diesel fuel.
(2)
Inspect all components for damage or excessive wear. Replace any components damaged or worn.
c.
Repair.
Repair is limited to replacement of defective parts.
5-10
|
