|
| |
TM 10-4320-311-14
Figure 4-14. Terminal Block
INSPECTION. Refer to Figure 4-14
Inspect the terminal block, located at the lower right rear of the frame-below the intervehicie connector, for
damage. Replace if damaged
REMOVAL:
a.
Observe and tag all wires (1)
b.
Remove tagged wires (1) from terminal block (2) by removing screws (3)
c.
Remove terminal block (2) from frame (4) by removing screws (5) and nuts (6)
INSTALLATION:
a.
Position terminal block (2) on frame (4) and secure with nuts (6) and screws (5)
b.
Secure tagged wires (1) to proper terminals on terminal block (2) using screws (3)
CAUTION
Wires Installed near hot or sharp operating surfaces will result In melted or damaged wire
Insulation causing a short circuit
WIRING HARNESS INSPECTION:
Inspect all wires for signs of melted or missing insulation, deterioration, or other damage. Replace if damaged.
4-30
|
