|
| |
TM 10-4320-311-14
c.
Remove flywheel end nut (3) and washer (4) from crankshaft (6).
d.
Using a puller, remove flywheel.
CAUTION
Be careful not to damage the taper part of the crankshaft.
e.
Remove flywheel key (7) from crankshaft (6).
INSTALLATION:
a.
Install flywheel key (7) onto crankshaft (6).
b.
Install flywheel (5) onto crankshaft (6)
c.
Install flywheel end nut (3) and washer (4).
d.
Tighten flywheel end nut (3) by bracing the flywheel by inserting a pry bar through a hole in the flywheel into
the depression in the crankcase. Torque flywheel end nut to 73-80 ft-lb (1000-1100 cm-kg).
6-27
|
