|
| |
TM 10-4320-311-14
6-11. Inspect/Replace Flywheel.
This task covers:
a.
Inspection
b.
Removal
c.
Installation
INITIAL SETUP
Tools
Materials/Parts
Tool Kit, General Mechanics (Item 1,
Diesel fuel (Item 2, Appendix E,
Appendix B, Section III)
Section II)
Puller (Item 3, Appendix B,
Equipment
Section III)
Condition
Torque Wrench, 0-150 ft-lb (Item 3,
Para
Appendix B, Section III)
4-30
Flywheel and cooling case cover
removed.
Figure 6-20. Crankshaft and Flywheel Assembly
INSPECTION:
Inspect the flywheel for damage. Replace If damaged
REMOVAL- Refer to Figure 6-20.
a.
Remove starter pulley (1) by removing three bolts (2).
b.
Brace the flywheel (5) to prevent the flywheel from turning while loosening the flywheel nut (3) by inserting a pry
bar through a hole in the flywheel into the depression In the crankcase
6-26
|
