|
| |
TM 10-4320-311-14
Figure 4-21. Fuel Selector Valve
d.
Secure fuel injector line (5) with clamp (4).
e.
Secure fuel tank line (3) with clamp (2).
f.
Open fuel cock (1) on fuel tank (7).
INSTALLATION'
a.
Refer to Figure 4-16 Position the sound enclosure front panel assembly on frame (6).
b.
Refer to Figure 4-20. Pull recoil starter rope T-handle (2) away from starter case until two feet of rope (1) is
exposed.
c.
Grasp rope (1) firmly and pull the knot six inches out of T-handle (2). Untie the temporary knot in rope (1).
d.
Feed rope (1) through front panel grommet (3).
e.
Feed rope (1) through the hole in T-handle (2). Feed enough rope (1) through T-handle (2) to make a knot.
f.
Tie a knot in rope (1) and pull it against the hole in T-handle (2). Stuff excess rope into the T-handle slot.
g.
Refer to Figure 4-16. From the outside of the sound enclosure front panel assembly, feed throttle cable (9) into
the hole in the front panel.
h.
Refer to Figure 4-19. On the inside of the sound enclosure front panel assembly, secure throttle cable mounting
(6) with washer (5) and nut (4).
i.
Attach cable (3) end to throttle control (1), then secure by tightening cable set screw (2).
j.
Refer to Figure 4-16. Push oil drain hose onto inside of panel fitting (8) and secure with clamp.
4-40
|
