|
| |
TM 10-4320-307-10
d.
During fueling and PMCS, do not allow sand or dust to enter fuel or lubrication system.
e.
Check that valve inside filler cap is open, fuel tank filler cap is tight, and gasket is not torn. Keep cap
tight to prevent foreign matter from entering the engine fuel tank.
f.
Keep stores of fuel and oil tightly sealed to prevent contamination.
g.
Close control panel cover whenever possible to limit damage to gage faces from blowing sand or grit.
h.
When pumping assembly is not in use and suction or discharge piping is not installed, cover the suction
flange (intake) and check valve assembly body port (discharge).
2-13 OPERATION IN SALT WATER AREAS. When the centrifugal pump unit is operated near salt water.
notify unit maintenance.
2-73
|
