| |
TM 10-3835-231-23P
(9) The statement "END OF FIGURE" appears just below the last item description in column five for a
given figure in both Sections II and III.
f. QTY, Column (6). The QTY (quantity per figure column) indicates the quantity of the item used in the
breakout shown on the illustration figure, which is prepared for a functional group, subfunctional group, or an
assembly. A "V" appearing in this column in lieu of a quantity indicates that the quantity is variable and the
quantity may vary from application to application.
4. EXPLANATION OF COLUMNS (SECTION IV).
a. National Stock Number (NSN) Index.
(1) Stock Number Column. This column lists the NSN by National Item Identification Number (NIIN)
sequence. The NIIN consists of the last nine digits of the NSN, i.e.,
NSN
(5305-01 -574-1467).
NIIN
When using this column to locate an item, ignore the first four digits of the NSN. However, the complete NSN
should be used when ordering items by stock number
(2) FIG. Column. This column lists the number of the figure where the item is identified/located. The
figures are in numerical order in Section II and Section III.
(3) ITEM Column. The item number identifies the item associated with the figure listed in the adjacent
FIG. column. This item is also identified by the NSN listed on the same line.
b. Part Number Index. Part numbers in this index are listed by part number in ascending alphanumeric
sequence (i.e., vertical arrangement of letter and number combination which places the first letter or digit of
each group in order A through Z, followed by the numbers ) through 9 and each following letter or digit in like
order).
(1) CAGEC Column. The Commercial And Government Entity Code (CAGEC) is a five digit numeric
code used to identify the manufacturer, distributor, or government agency, etc., that supplies the item.
(2) Part Number Column. Indicates the primary number used by the manufacturer (individual, firm,
corporation, or Government activity), which controls the design and characteristics of the item by means of its
engineering drawings, specifications standards, and inspection requirements to identify an item or range of
items.
(3) Stock Number Column. This column lists the NSN for the associated part number and
manufacturer identified in the PART NUMBER and CAGEC columns to the left.
(4) Fig. Column. This column lists the number of the figure where the item is identified/located in
Sections II and III.
(5) Item Column. The item number is that number assigned to the item as it appears in the figure
referenced in the adjacent figure number column.
c. FIGURE AND ITEM NUMBER INDEX.
(1) Fig. Column. This column lists the number of the figure where the item is identified/located in
Sections II and III.
(2) Item Column. The item number is that number assigned to the item as it appears in the
figure referenced in the adjacent figure number column.
(3) Stock Number Column. This column lists the NSN for the associated part number and
manufacturer identified in the PART NUMBER and CAGEC columns to the left.
5
|