|
| |
TM 10-3835-231-13
4-6. INSTALLATION OF SAFETY AND NO SMOKING SIGNS. - continued
c.
To minimize the threat of smokers, create a well-marked "Smoking Permitted" area well away from the facilities
and make that the only area in which smoking is permitted.
d.
Set up "Shut Engine Off' signs at fuel dispensing and receiving areas.
e.
Set up "Disconnect Hose before Moving Vehicle" signs at dispensing and receiving areas.
f.
Place the following safety signs at appropriate locations:
Danger - Hot Surfaces" - at pump engines.
Danger - Moving Parts" - at pump and engines.
Danger - Wear Goggles and Gloves" - at sampling position.
Watch Your Step" - in congested areas.
4-7. CONTAMINATED FUEL MODULE ASSEMBLY.
a
Locate and install 2 each 50,000 gallon collapsible fabric tanks (1) (see figure 4-6). See para 4-4 and TM 10-
5430-219-12. Be sure that elbows, hoses, and valves supplied with tanks are installed.
WARNING
GROUNDING AND BONDING
Pumps must be grounded at time of installation to prevent explosion or fire.
CAUTION
Install pump as far away from the tanks it serves without bridging the suction hose
or deforming the tank top. Pump engine and exhaust fumes are hot and distance
from tanks enhances safety.
b.
Prepare 350 GPM pump (2) for use in accordance with TM 5-4320-226-14 or TM 10-4320-324-14 as applicable.
Observe all warnings and cautions.
c.
Connect 2 each 6-inch x 4-inch reducers (3) to tank (1) elbows.
d.
Check that quick disconnect gaskets (4) are in place and connect 2 each Cam-lock adapter (5).
NOTE
Liberally apply petrolatum to the gasket and the inside surface of coupling clamp to
prevent pinching during installation. Then, pull the coupling gasket over one
grooved end of each mating joint. Ensure gasket is properly positioned over full
circumference of sealing surfaces. Position coupling clamp over gasket. While
maintaining alignment of mating parts, lock coupling, lamp securely.
e.
Connect 4 each 6-inch x 50-foot hose assemblies (7) using coupling clamps (6).
f.
Install 2 each gate valve (8) using coupling clamps (6).
g.
Connect gate valves (8) to tee (9) using coupling clamps (6).
h.
Connect remaining 6-inch x 50-foot hose (7) to tee (9) using coupling clamp (6).
4-18
|
