|
| |
TM 10-3835-231-13
l.
The following installation/assembly instructions are provided as a guideline; they may be modified depending upon
local operational requirements.
Para
Component
4-5 ............................Fire Suppression Equipment
4-7 ............................Cont aminated Fuel Module
4-8 ............................Switching Manifold
4-9 ............................Tank Farm Assembly
4-10..........................Range Pole Installation
4-11..........................Fuel Dispensing Assembly
4-12..........................Tanker-Truck Receipt Manifold
4-13..........................50,000 Gallon Tank TPT Optional Configuration
4-14..........................Transfer Hoseline
4-15..........................Nestable Culverts
4-16..........................Floodlight Sets
4-17..........................Hoseline Suspension Set
4-18..........................Area Cleanup and Corrective Painting
4-19..........................Final Inspection of Assembled Items
4-5.
FIRE SUPPRESSION EQUIPMENT.
Check out, service, and install the fire suppression equipment in accordance with TM 104120-235-13 and specific
instruction of operating management.
a.
The wheel-mounted dry chemical/AFFF units should be located such that they can be readily put into service at
the fuel storage units, fuel dispensing sets, the switching manifold, the contaminated fuel module and the tanker-truck off
loading area. See TM 10-4120-253-13 for instructions on the dry chemical AFFF unit. See (figures 4-1 and 4-2) for
recommended locations of the wheel-mounted dry chemical/AFFF units.
b.
It is recommended that one 20 lb fire extinguisher be placed near each pump, floodlight, and loading spot.
Placement of the extra extinguishers not specifically located should be placed according to the direct operating authority.
NOTE
Thoroughly check out all fire suppression equipment when placed in the unit. Extinguishing
equipment must be charged and in working order. Clothing must be clean and in good
condition.
Clearly mark storage areas for fire suppression equipment and educate all personnel on its
location and use prior to bringing flammable fuels to any part of the system.
4-6.
INSTALLATION OF SAFETY AND NO SMOKING SIGNS.
Prepare and install appropriate safety and no smoking signs at locations designated by operating management for the
specific site. The following criterion is recommended:
a.
No smoking within 50 ft. of any system or equipment containing flammable fuels. Set up "No Smoking" signs.
b.
Set up "No Smoking" signs around fuel dispensing and fuel receipt area.
4-17
|
