|
| |
TM 10-4320-343-14
4.13.7 Safety Relay K1 Replacement.
This task covers:
4.13.7.1 Removal
4 .
1
3 .
7 .2
I n s t a l l a t i on
INITIAL SETUP
Tools
General Mechanic’s Tool Kit (appendix B,
Section III, Item 1)
Equipment Conditions
Equipment shut down, refer to
paragraph 2.5.1.2 or 2.5.2.2.
General Safety Instructions
To prevent rolling or sliding, do not
work on equipment that is not securely
s t a b i l i z e d .
Do not work on equipment without
following standard shop safety
precautions.
Control Panel Assembly Cover removed,
paragraph 4.13.1.
Figure 4-47.
Safety Relay (K1) Replacemnt.
4.13.7.1 Removal.
To prevent rolling or sliding,
do not work on equipment that is not
s e c u r e l y s t a b i l i z e d.
Ensure both wheels are secure.
Failure to obey this
warning may result in serious personal injury.
a.
Remove retainer clip (figure 4-47, 1) from relay (2).
b.
Remove relay (2) from socket (3) .
4.13.7.2 Installation.
a.
Install relay (2) into socket (3).
b.
Secure relay (2) by lifting retainer clip (1) over relay (2).
4-90
|
