|
| |
TM10-4320-324-14
6-9. Cylinder Head Repair.
This task covers:
a.
Disassembly
c.
Repair
e.
Follow-on Maintenance
b. Cleaning/Inspection
d.
Assembly
INITIAL SETUP:
Tools
Tools
Pilot pin, item 9, section III, appendix B
Tool set, general mechanics, item 35, section III,
Cutter, item 10, section III, appendix B
appendix B
Mandrel, item 11, section III, appendix B
Reamer, item 12, section III, appendix B
Materials/Parts
Mandrel (intake), item 13, section III, appendix B
Washer - 111 8760
Mandrel (exhaust), item 14, section III,
Washer - 111 8760
appendix B
Solvent, dry cleaning, item 15, appendix E
Cutting device, item 15, section III, appendix B
Cloth, lint-free, item 3, appendix E
Valve spring compressor, item 25, section III,
appendix B
Equipment Condition
Micrometer, item 34, section III, appendix B
Cylinder head assembly removed (para 5-22).
Depth gauge, item 34, section III, appendix B
Arbor press, item 34, section III, appendix B
General Safety Instructions
Drill, item 34, section III, appendix B
Wear personal protective equipment when using
Clamping stand, item 38, section III, appendix B
cleaning solvent or compressed air for cleaning
Plate, item 39, section III, appendix B
purposes.
Heating of head to install components is
required. Do not touch hot parts without heavy
gloves. Severe burns can result.
a.
Disassembly.
(1) Install cylinder head (1) in clamping stand.
6-35
|
