Location and Description of Major Components

T M 1 0 - 3 8 3 5 - 2 1 9 - 1 4 1-9. Location and Description of Major Components. (Model No. 1461) (figure 1-7). SLING ASSEMBLY. Used for lifting flaking boxes. Constructed of steel pipe, wire cables, attach hooks, and lift ring. HOSE ASSEMBLY AND FLAKING BOX. The hoseline outfit consists of 13 hose assembly and flaking boxes. Each hose consists of two 500-foot (150m) sections of collapsible hose coupled together per flaking box. The flaking box provides for packing and transportation of the hoses. Steel weldment construction with lifting provisions. ROADWAY CROSSING GUARD. The hoseline outfit consists of 20 roadway crossing guards. The guard is a steel channel that provides protection of hoseline when routed under road surfaces and train tracks. DISPLACEMENT AND EVACUATION KIT CHEST ASSEMBLY (figure 1-8). A welded assembly that contains compartments for the storage of the displacement and evacuation kit. The displacement and evacuation kit consists of an ejector assembly, ball inlet, displacement ball, ball receiver assembly, eight pipe coupling clamps, and 16 pipe caps. The kit is used to remove liquid fuel, vapors, and air from hoselines so that they can be easily packed into flaking boxes. REPAIR KIT CHEST ASSEMBLY (figure 1–9). A welded assembly that contains compartments for the storage of the repair kit. The repair kit consists of four hose clamps, a banding tool, a box of strapping seals (banding buckles), three quarts (2.85LO of cleaning solvent, five cans of rubber adhesive, a hammer, a 5-pound (2.27 kg) pack of wiping rags, 350 ft. vinyl tape, a common screwdriver, a knife, a 1-1/16 inch socket, a socket wrench, 150 ft. rubber tape, two 100-foot (30m) rolls of strapping, two T handle hex keys, ten hose adapters, eight hose clamps, and two coupling strapping rings assemblies. This kit is used to repair hoselines. SUSPENSION KIT CHEST ASSEMBLY (figure 1-10). A welded assembly that contains compartments for the storage of the suspension kit. The suspension kit consists of four tackle blocks, 25 wire rope clamps, a 350-foot (105m) spool of wire rope, a 350-foot (105m) spool of manila rope, 60 fabric hose saddles, 60 shackles, 14 guy stakes, four wire rope thimbles, and four turnbuckles. PACKING KIT CHEST ASSEMBLY (figure 1-1 1.). A welded assembly that is used for storage of the packing kit. The packing kit consists of a pullboard assembly, two left- and two right-hand hose-retaining brackets, and a 3/4- ton (675 Kg) chain hoist. FLOW CONTROL KIT ASSEMBLY (figure 1-1 2). A welded assembly that contains compartments for the storage of the flow control kit. The flow control kit consists of eight pipe coupling clamps, two coupling halves quick disconnect (female), two coupling halves quick disconnect (male), two hose assemblies, two grooved-to-external- thread couplings, two grooved-to-internal-thread couplings, a strainer assembly, two check valves, a tee, steel fish tape, two gate valves, and a metal chest assembly. The kit is used to control the flow of fuel in the hoseline under all operating conditions. C h a n g e 1 1-8.1 (l-8.2 Blank)