|
| |
TM 10-3835-219-14
Section VI. PREPARATION FOR SHIPMENT OR STORAGE
Paragraph
P a g e
4 - 1 3
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-9
4 - 1 4
Preparation for Shipment or Storage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-9
4 - 1 5
Administrative Storage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...4-12
4-13. General. This section contains procedures to place fuel handling hoseline outfit into short term or administrative
storage.
4-14. Preparation for Shipment or Storage.
a.
Long Term Storage. (Figure 4-3)
(1) Hoseline outfit. The hoseline outfit must be kept off the ground on shipping pallets, skids or tarpaulins.
(2) Hoseline. Hoseline packaged as supplied or boxed after use, must be Stored orunder cover in a supply ware-
house or tent where it is relatively cool, dark and free from dampness and mildew. Storage temperature should be 50
to 70°F (10-21°C) with a maximum temperature of 100° (58°C). Do not store hoseline near sources of heat, such as radia
tors, base heaters, etc. Do not store under conditions of high or low humidity.
(3) Hoseline kits. All hoseline kits are stored in their original storage containers and preserved as follows:
(a) Displacement and evacuation kit and repair kit.
1 Completely wrap the land-sealing surface of grooved end fittings with a single wrap of barrier ma-
terial conforming to MIL-B-121, Type II, Class 2. The wrap must be flush with end of fitting and extend back beyond groove
not less than one quarter of an inch.
2 Cover wrap of barrier material with a single wrap of tape conforming to PPP-T-60, Type IV. The
tape must be of a width that willi completely cover the barrier material and extend not less than one eighth of an inch beyond
end of fitting and extend back beyond barrier material not less than one ham of an inch.
3 Roll tape extending beyond end of fitting and wrap in place against end wall of fitting and against fitting.
4 For Model No. ADC-1200, coat all unpainted metal components with contact preservative, Type
P-1 or P-19 in accordance with MIL-P-116.
5 For Model No. 1461, coat all unpainted metal components with contact preservative, Type F or
G, as applicable, in accordance with MIL-T-704.
6 Place all components in chest in accordance with Table 2-5, Table 2-8, or Table 2-9, as applicable.
7 Close chest and seal edges of chest lid with tape conforming to PPP-T-60, Type IV.
Change 1 4 - 9
|
