|
| |
T M 1 0 - 3 8 3 5 - 2 1 9 - 14
S
B
C
Figure 4-3. Long Term Storage.
(b) Flow control kit.
1 Completely wrap the land-sealing surface of grooved end fittings with a single wrap of barrier ma-
terial conforming to MIL-B-121, Type II, Class 2. The wrap must be flush with end of fitting and extend back beyond groove
not less than one quarter of an inch.
2 Cover wrap of barrier material with a single wrap of tape conforming to PPP-T-60, Type IV. The
ape must be of a width that will completely cover the barrier material and extend not less than one eighth of an inch beyond
end of fitting and extend back beyond barrier material not less than one half of an inch.
3 Roll tape, extending beyond end of fitting and wrap in place against end wall of fitting and against
fitting.
4 Place all components in chest in accordance with Table 2-6 or Table 2-10, as applicable.
5 Close chest and seal edges of chest lid with tape conforming to PPP-T-60, Type IV.
4 - 1 0
|
