|
| |
TM 9-2330-398-24
EXPECTED TEMPERATURE*
LUBRICANT
INTERVALS
Above +32°F
+40°F to -10°F
0°F to -65°F
(Above 0°C)
(+4°C to -23°C)
(-18°C to -54°C)
OE/HDO
OE/HDO
OE/HDO
M - Monthly
(MIL-L-2104D)
15W40
15W40
H100 - 100 Hours of
Lubricating-Oil,
Internal
operation
Combustion Engine,
OEA
Tactical Service
(See Note 1)
SA - Semiannual
PL
PL-Medium
PL-Special
PL-Special
A - Annual
(PL-S-W-L-800 or
PL-M-MIL-L-3150)
Preservative Oil
OEA
All Temperatures
(MIL-L-46167)
Lubricating Oil,
Internal
Combustion, Arctic
GAA
All Temperatures
(MIL-G-23827)
Grease, Automotive
and Artillery
* For Arctic operations,
refer to FM 9-207.
NOTES:
1.
For operation of equipment in extreme cold
temperatures below -10°F ( -23°C), remove
lubricants prescribed in the key for temperatures
above -1 0°F (-230C). Relubricate with
lubricants specified in the key for temperatures
below 0°F, (-180C). lf OEA lubricant is required
to meet the temperature changes prescribed in
the key, OEA lubricant is to be used in place of
OE/HDO-10 lubricant for all temperature ranges
where OE/ HDO-10 lubricant is specified in the
key.
2.
Grease lubrication fittings until grease appears.
Slack adjusters and camshaft bearings are
located on both sides of front and rear axles.
3.
Remove pipe plug from housing. Fill with oil to
bottom of pipe plug hole. Wipe pipe plug clean
with drycleaning solvent (Item 12, Appendix C)
and dry with a rag (Item 25, Appendix C), and
install pipe plug in housing.
4.
Remove drain plug from crankcase. Clean pipe
plug with drycleaning solvent (Item 12, Appendix
C) and wipe with clean rag (Item 25, Appendix
C). Install pipe plug in crankcase. Refill capacity
is 6 quarts (5.7 L). Add 1 pint (0.4 L) more
engine oil filter has been replaced.
5.
Remove wheel bearings (para 2-64). Clean and
repack bearings with GAA until all spaces
between rollers are filled with grease and no air
bubbles are present. Install wheel bearings
(para 2-64).
G-5/(G-6 blank)
|
