|
| |
TM 9-2330-398-24
4-1.
ENGINE ASSEMBLY REPAIR (continued).
5.
Remove four standpipe vents (27) from two
cylinder heads (28).
6.
Remove eight nuts (24), rocker arm balls (23),
and rocker arms (22) from two cylinder heads
(28).
CAUTION
To prevent damage to cylinder heads
do not use a prybar or strike cooling
fins.
NOTE
If cylinder heads stick, tap them gently
with soft hammer.
7.
Remove 10 screws (25), two push rod guide
plates (26), 12 screws (36) and washers (37),
eight push rods (35), and two cylinder heads (28)
from engine (1).
8.
Remove eight push rod shields (34), 16 packings
(31), eight springs (33), 16 washers (31), eight
tappets (30), and two cylinder head gaskets (29)
from engine (1). Discard packings and gaskets.
CAUTION
Do not attempt to pry oil base free of
cylinder block. If necessary, use soft
mallet to separate oil base.
4-4
|
