|
| |
TM 9-2330-398-24
3-23.
ENGINE THROTTLE AND CHOKE LINKAGE REPLACEMENT (continued).
NOTE
Do not perform step 6 if throttle cable needs to be adjusted.
6.
Install engine door panel (2) on engine (3) with two retaining screws (1).
c.
THROTTLE CABLE ADJUSTMENT
NOTE
•
Perform step 1 only if removal and
installation steps have not been performed.
•
Engine should be adjusted to low idle speed
(900 rpm).
1.
Loosen two retaining screws (1), and remove engine
door panel (2) from engine (3).
2.
Start engine (refer to TM 9-2330-398-10).
3.
To increase engine speed, loosen jamnut (21) on
outside of engine shrouding (14) and tighten inside
jamnut (13).
4.
To decrease engine speed, loose pin side jamnut
(13) and tighten outside jamnut (21).
5.
Stop engine (refer to TM 9-2330-38-10).
6.
Install engine door panel (2) on engine (3) with two
retaining screws (1).
FOLLOW-ON MAINTENANCE:
•
Disconnect ground (refer to TM 9-2330-398-10)
3-73
|
