|
| |
TM 9-2330-398-24
Section V. BODY, CAB, HOOD, AND HULL MAINTENANCE
Paragraph
Page
Number
Paragraph Title
Number
3-12
General ..................................................................................................................................................3-38
3-13
11/4-lnch Hose Reel Assembly Replacement .......................................................................................3-38
3-14
Hose Reel Cabinet Replacement ..........................................................................................................3-42
3-15
Hose Reel Cabinet Access Door Repair ...............................................................................................3-46
3-16
Engine and Pump Cabinet Frame Replacement ...................................................................................3-48
3-12. GENERAL.
This section describes and illustrates removal and installation procedures for the 11/4-inch hose reel assembly, the hose
reel cabinet, and the engine and pump cabinet frame. This section also describes and illustrates repair procedures for the
hose reel cabinet access door.
3-13. 11/4-NCH HOSE REEL ASSEMBLY REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
Equipment Conditions:
• General mechanic's tool kit (Item 4,
• Semitrailer uncoupled (refer to TM 9-2330-398-10).
Appendix B)
• Semitrailer bonded and grounded (refer to
TM 9-2330-398-10).
Material/Parts:
• Hose reel cabinet removed (para 3-14).
• Lockwasher (2) (Item 91, Appendix F)
•· Lockwasher (4) (Item 96, Appendix F)
Personnel Required: Two
• Seal (Item 149, Appendix F)
• Self-locking nut (4) (Item 172, Appendix F)
a.
REMOVAL
1. Remove four screws (14), lockwashers (13), and cover (12) from motor junction box (5). Discard lockwashers.
2. Remove one screw (1), two washers (2), and one lockwasher (3), and electrical lead (11) from terminal board (6).
Discard lockwashers.
3. Remove one screw (1), two nuts (7), two washers (2), one lockwasher (8), and electrical lead (1 1) from terminal
·_ board (6).
4. Remove bushing (9), and conduit (10) with two leads (11), from motor junction box (5).
5. Remove capacitors (4).
3-38
|
