|
| |
TM 9-2330-398-24
CHAPTER 2
UNIT MAINTENANCE
Section I. REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC
EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT
Paragraph
Page
Number
Paragraph Title
Number
2-1
General.................................................................................................................................................2-1
2-2
Common Tools and Equipment............................................................................................................2-1
2-3
Special Tools, TMDE, and Support Equipment....................................................................................2-1
2-4
Repair Parts .........................................................................................................................................2-1
2-1.
GENERAL.
This chapter describes the Unit maintenance tasks to be performed on the M969A2 semitrailer.
2-2.
COMMON TOOLS AND EQUIPMENT.
Common tools and equipment are issued to Unit maintenance personnel for maintaining the semitrailer. Common tools
and equipment should not be used for purposes other than those prescribed and should be properly stored when not in
use. For authorized common tools and equipment, refer to the Modification Table of Organization and Equipment
(MTOE), CTA 50-970, or CTA 8-100, as applicable to your unit.
2-3.
SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT.
Special tools, TMDE, and support equipment are authorized for the M969A2 semitrailer. Refer to Appendix B of this
manual and to TM 9-2330-398-24P.
2-4.
REPAIR PARTS.
a.
Repair parts are listed and illustrated in TM 9-2330-398-24P, the repair parts and special tools list (RPSTL), which
covers Unit, Direct Support, and General Support maintenance for the M969A2 semitrailer.
b.
Mandatory replacement parts, such as gaskets, preformed packings, seals, lockwashers, self-locking nuts, cotter
pins, and spring pins, are listed in the Initial Setup section of each maintenance task paragraph and are
referenced to Appendix F for detailed information. Bushings must be replaced only if removed.
c.
Springs must be replaced if broken, kinked, or cracked or if they do not conform to standards specified in the
repair procedures.
2-1
|
