|
| |
TM 9-2330-398-24
2-120. FILTER SEPARATOR FILTER ELEMENTS REPLACEMENT (M & E INDUSTRIES MODEL).
This Task Covers:
a. Removal
b. Disassembly
c. Assembly
d. Installation
Initial Setup:
Tools/Test Equipment:
•
Lockwasher (8) (Item 106, Appendix F)
•
General mechanic's tool kit (Item 4, Appendix B)
Equipment Conditions:
Materials/Parts:
•
Semitrailer uncoupled (refer to TM 9-2330-398-10).
•
Drycleaning solvent (Item 12, Appendix C)
•
Semitrailer bonded and grounded (refer to
•
Petrolatum (Item 24, Appendix C)
TM 9-2330-398-10).
•
Rag (Item 25, Appendix C)
•
All fuel dispensing valves closed (refer to
•
Antipilferage seal (2) (Item 1, Appendix F)
TM 9-2330-398-10).
•
Gasket (Item 25, Appendix C)
•
Semitrailer drained (refer to TM 9-2330-398-10).
•
Gasket (5) (Item 26, Appendix F)
•
Negative battery disconnected (para 2-33).
•
Gasket (10) (Item 27, Appendix F)
•
Lockwasher (12) (Item 105, Appendix F)
a.
REMOVAL
WARNING
Read and observe all safety precautions listed in the Warning Summary before
performing any maintenance on filter separator. Make sure semitrailer is grounded
to an approved (earth) ground and it is safe to proceed. Failure to follow this
warning may cause a spark to ignite, resulting in serious injury or death to
personnel.
NOTE
•
Semitrailer is equipped with five filter assemblies in the rear of the filter separator and 15 filter elements In
the front. Removal of all five filter assemblies and 15 filter elements is the same. One of each Is shown.
•
Make sure all valves are closed.
2-258
|
