|
| |
TM 9-2330-398-24
2-103. ENGINE ELECTRICAL BOX REPAIR (continued).
9.
Remove two screws (19) and lockwashers (18) and solenoid (20) from mounting plate (26).
10.
Remove four screws (25) and lockwashers (24) and terminal board (23) from electrical box (7). Discard
lockwasher.
b. INSTALLATION
1.
Install terminal board (23), four new lockwashers (24), and screws (25) on mounting plate (26).
2.
Install solenoid (20) and two new lockwashers (18) and screws (19) on mounting plate (26).
3.
Install circuit breaker (21) and two screws (22) on mounting plate(26).
4.
Install circuit breaker (29) and two new lockwashers (28) and screws (27) on mounting plate (26).
5.
Install electrical box (7) and two capscrews (9) and nuts (4) on angle mounting plate (3).
6.
Install mounting plate (26) and two lockwashers (18) and screws (19) on electrical box (7).
7.
Install five new preformed packing (6), electrical connectors (5), and new locknuts (17) on electrical box (7).
8.
Install wiring harness (2) and four capscrews (1), new lockwashers (16), and nuts (15) on electrical box (7).
9.
Connect all electrical leads in electrical box (7).
10.
Install new gasket (12) on electrical box cover (10), close cover (10), and tighten two clip screws (8).
2-218
|
