|
| |
TM 9-2350-253-34-2
2-88. REFLECTOR REPLACEMENT (continued).
b.
INSTALLATION
NOTE
Surface must be clean and dry before installing reflector. If reflector is attached with
adhesive, go to step 1; if reflector is attached with screws, go to step 3.
1.
Remove protective backing from new reflector (4) and position on semitrailer.
2.
Using dry rag, press reflector (4) into position. Start in center of reflector (4) and press outward, to remove
any air bubbles.
3.
Secure reflector (4) on semitrailer with two screws (1), washers (2), and self-locking nuts (3).
FOLLOW-ON MAINTENANCE:
•
Disconnect ground (refer to TM 9-2330-398-10).
2-189
|
