|
| |
TM 9-2330-398-24
2-46. WIRING HARNESS AND LEAD ASSEMBLY REPAIR.
This Task Covers:
a. Disassembly
b. Assembly
Initial Setup:
Tool Test Equipments:
Equipment Conditions
• General mechanic's tool kit (Item 4, Appendix B)
• Semitrailer uncoupled (refer to TM 9-2330-39810).
• Semitrailer bonded and grounded (refer to
Material/Parts:
TM 9-2330-398-10).
• Tape, insulation, electrical (Item 31, Appendix C)
NOTE
This task applies to all wiring harnesses and lead assemblies. See illustration for
location of wiring harnesses and lead assemblies.
a. DISASSEMBLY
1. Remove any loose or damaged connectors from wiring harness/lead assembly.
NOTE
Remove electrical insulation tape only from section of wiring harness/lead
assembly to be disassembled.
2. Remove electrical insulation tape from section of wiring harness/lead assembly.
3. Separate and isolate wiring harness/lead assembly branches.
4. Disassemble each wiring harnessed assembly branch and replace defective wires.
b. ASSEMBLY
1. 4leassemble each wiring harness/lead assembly branch.
2. Regroup wiring harness/lead assembly branches and secure with electrical insulation tape.
3. Install new connectors on wiring harness/lead assembly as required.
2-118
|
