|
| |
TM 9-2330-398-24
2-43.
WIRING HARNESS 12356095 REPLACEMENT.
This Task Covers:
a.
Removal
b.
Installation
Initial Setup:
Tools/Test Equipment:
•
Semitrailer bonded and grounded (refer to
•
General mechanic's tool kit (Item 4, Appendix B)
TM 9-2330-398-10).
•
Composite light cover plates removed (para 2-30).
Equipment Conditions:
•
Semitrailer uncoupled (refer to TM 9-2330-398-10).
NOTE
•
Composite light boxes are located on curb side and road side of semitrailer. Removal of cover plate
is common for both boxes.
•
Connectors must be removed in order to pull wiring harness through conduit.
a.
REMOVAL
1.
From inside road-side and curb-side composite light boxes (2 and 4), tag and disconnect lead 490 connectors (8
and 9) of wiring harness 12356095 (10) from lead 490 connectors of blackout clearance lights (1 and 5). From
inside curb-side light box (4), cut lead 490 connectors (8) from lead 490.
2.
From inside road-side composite light box (2), tag and disconnect lead 490 connector (11) of wiring harness
12356095 (10) from lead 490 connector (7) of front blackout marker lights wiring harness (6).
3.
Pull wiring harness 12356095 (10) through conduit (3) and out through road-side composite light box (2).
b.
INSTALLATION
NOTE
Repair wiring harness as required (para 2-46).
1.
Pull lead 490 (8) through conduit (3) and out through curb-side composite light box (4).
2.
Install new connector on lead 490.
3.
Inside road-side composite light box (2), connect lead 490 connector (11) of wiring harness 12356095 (10) to lead
490 connector (7) of front blackout marker lights wiring harness (6).
2-112
|
