|
| |
TM 9-2330-272-14
4-60. STOWAGE TUBE ASSEMBLY REPLACEMENT.
This Task Covers.
Initial Setup.
Equipment Conditions:
Materials/Parts:
l Stowage tubes empty.
l Adhesive (Item 1, Appendix E)
l Two grommet strips
l Six Iockwashers (M131A4 and M131A4C)
Tools/Test Equipment:
l Thirteen Iockwashers (M131A5 and M131A5C)
l GeneraI mechanic’s tool kit
Personnel Required: Two
a .
REMOVAL
1.
2.
3.
4.
5.
6.
7.
8.
9.
NOTE
If removing stowage tube assembly on M131A5 or M131A5C, perform steps 1
through 5.
Stowage tube assembly on M131A4 and M131A4C is welded to semitrailer.
Maintenance for M131A4 and M131A4C stowage tube assembly is limited to
replacement of grommet strips and fasteners on end assemblies. Perform only steps
6 through 9 for these models.
Remove padlocks from front and rear stowage tube end assemblies (27 and 3) arid open doors.
Remove three nuts (1 2), Iockwashers (11), screws (4), and washers (5) from rear stowage tube end assembly (3)
and support (10). Discard Iockwashers.
Remove two nuts (17), Iockwashers (16), screws (13), and washers (14) from bracket (15). Discard
Iockwashers.
Remove two nuts (25), Iockwashers (26), screws (19), and washers (20) from front stowage tube end assembly
(27). Discard Iockwashers.
Remove stowage tube assembly (1) from semitrailer.
Remove grommet strip (2) from rear stowage tube end assembly (3), Discard grommet strip
Remove three nuts (6), Iockwashers (7), screws (9), and fastener (8) from rear stowage tube end assembly (3).
Discard lockwashers.
Remove grommet strip (18) from front stowage tube end assembly (27). Discard grommet strip.
Remove three nuts (21), Iockwashers (22), screws (24), and fastener (23) from front stowage tube end assembly
(27). Discard Iockwashers.
4-118
|
