| |
TM 9-2330-272-14
4-54. TORQUE ROD REPLACEMENT (Cont).
b.
CLEANING AND INSPECTION
1.
Clean rubber parts with water and a scrub brush.
WARNING
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open flame or excessive heat.
The solvents flash point is 100°F-138°F (38°C-59°C). If you become dizzy while
using cleaning solvent, Immediately get fresh air and medical help. If solvent contacts
eyes, immediately wash your eyes and get medical aid.
2.
Clean all other parts with dry cleaning solvent. Allow to dry.
3.
lnspect rubber on two ball assembles (4 and 6) for loss of elasticity, breaks in material, and secure mounting in
torque rod. Notify Direct Support Maintenance if damaged or loose.
c.
INSTALLATION
1.
Position torque rod (5) in mounting bracket (7).
2.
Position torque rod (5) in axle bracket (3) and install two slotted nuts (1) and new cotter pins (2).
FOLLOW-ON TASKS:
l Install spring (upper torque rod replacement only) (para 4-52).
4-111
|