| |
TM 55-4920-383-13&P
NOTE
As reassembly proceeds, reconnect wires and cables in accordance with tags on
wires. Check that wires and cables are connected to proper terminal or connector
and remove tags.
a. Attach two brackets (2) to power supply board (3) using two screws (1) and two
nuts (4).
b. Attach power supply board assembly (3) to panel assembly (17) using five screws
(18).
c. Secure bracket (62), post (5) and post (9) to power supply board assembly (3) using
three screws (10) and three flat washers (11).
d. Mount two bushings (8) on panel assembly (17).
e. Attach air capacitor board assembly (7) to panel assembly (17) using two screws
(10) and two flat washers (11).
f .
Mount interboard plate (6) between post (6) and air capacitor board assembly (7).
Secure air capacitor board assembly (7) and interboard plate (6) to post (5) using screw
(10) and flat washer (11).
g .
Secure sir capacitor board assembly (7) to bracket (62) using screw
flat washer (11).
h. Mount two O-rings (20) and two flat washers (21) over air capacitor
to panel assembly (17) using two hex nuts (25).
i. Install two shouldered washers (14) in panel assembly (17).
(10) and
shafts and secure
j. Mount insulator (13) over switch shafts of simulator board assembly (12).
k. Attach simulator board assembly (12) to panel assembly (17) using screw (10).
Secure simulator board assembly (12) to interboard plate (6) and post (9) using two
screws (10) and two flat washers (11).
4-29
|