|
| |
TM 5-5430-219-13
7 Remove stem (3) from bonnet (5).
8 Remove packing (9) from bonnet (5).
SERVICE
Cleaning solvent, P-D-680, used to clean parts, is potentially
dangerous to personnel and property. It produces toxic and
flammable fumes.
Use only in well–ventilated areas. Avoid
repeated and prolonged skin contact.
Do not use near an open
flame or excessive heat.
The flash point of solvent is 100°F to
138°F (38°C to 59°C).
1 Clean all parts with cleaning solvent and dry thoroughly.
2 Inspect all mechanical parts for cracks, dents, breaks, or wear.
Replace or repair if unserviceable.
3 Polish stem with a crocus cloth; then coat with grease.
ASSEMBLY (See figure 3-13.)
1 Lay valve body (7) on its side on a clean surface.
2 Insert wedge disks (8) into slot in valve body (7).
3 Insert stem (3) in bonnet (5).
4 Install bonnet (5) in valve body (7).
5 Install packing (9) in bonnet (5).
6 Install packing gland (6) in bonnet (5).
7 Install packing nut (4) on bonnet (5).
8 Install handwheel (2) on stem (3).
9 Install handwheel nut (1) on stem (3) above handwheel (2).
INSTALLATION (See figure 3-12.)
1 Using thread sealing compound or antiseize tape, coat threads (3) of
drain hose assembly (2).
2 Install drain gate valve (1) on drain hose assembly (2).
3-28
|
