|
| |
CAUTION
TM 5-4930-237-10
2-12. Operation of D1 Nozzle.
a. Wipe around fuel receptacle with a clean cloth (Item 1, Appendix D) to remove dirt or dust.
b. Remove fuel cap from fuel receptacle.
c. Remove dust cap (49).
d. Connect D1 nozzle (48) to fuel receptacle as follows
(1) Grasp handle grips and align inlet with fuel receptacle.
(2) Press D1 nozzle (48) against fuel receptacle and turn to align pins.
(3) Push D1 nozzle (48) against fuel receptacle and turn clockwise until nozzle stops.
e. Turn flow handle (54) to full OPEN position.
f. When fuel tank is full turn flow handle (54) to CLOSED position.
g. Turn D1 nozzle (48) counterclockwise and remove from fuel receptacle.
h. Install dust cap (49).
i. Install fuel cap on fuel receptacle.
j. Wipe exterior of D1 nozzle (48) and fuel receptacle with a clean cloth (Item 1, Appendix D) to remove dust or
fuel.
Do not leave nozzle laying on ground. Failure to comply can result in damage.
k. Place D1 nozzle (48) in storage container away from aircraft.
Change 1
2-16.1/(2-16.2 Blank)
|
