|
| |
TM 5-4930-235-13&P
f. Installation (Cam-Lock).
NOTE
The following procedures are for installation of the nozzle inlet assembly.
(1) Apply a light, even coat of thread sealing compound to threads of nozzle inlet assembly (14). Wipe off
excess.
(2) Clamp nozzle inlet assembly (14) in a vise on flats with strainer housing (24) pointing up.
CAUTION
Do not over tighten. Failure to comply can result in damage to parts.
(3) Thread nozzle (1) onto nozzle inlet assembly (14) until one to three threads are exposed. Wipe off
excess thread sealing compound.
(4) Attach wire rope (16) to ring (13).
48. Outlet Cap Assembly. (See Figure 4-1).
INITIAL SETUP
This task covers: Removal, Disassembly, Inspection, Replacement, Reassembly, and Installation.
Tools
Common hand tools from automotive shop set.
Materials/Parts
Lint-Free Cloth, MIL-C-85043 (Item 1, Appendix F)
Wire Rope, MIL-W-83420, Type II, Comp B 1/8 (Figure 1, Appendix G)
a. Removal.
(1) Remove wire rope (27) from ring (13).
(2) Remove outlet cap assembly (25) from nozzle (1).
(3) Wipe parts with a clean cloth to remove dirt and fuel.
b. Disassembly.
(1) Remove O-ring (28) from outlet cap (29).
CAUTION
The wire rope should not be removed from outlet cap unless damaged and replacement is required.
(2) Cut wire rope (27) between sleeve (26) and outlet cap (29).
(3) Remove wire rope (27) from outlet cap (29).
Change 1
4-9
|
