|
| |
TM 5-4930-234-13&P
(3) Items that are included in kits and sets are listed below the name of the kit or set.
(4) Spare/repair parts that make up an assembled item are listed immediately following
the assembled item line entry.
(5) Part numbers for bulk materials are referenced in this column in the line item entry for
the item to be manufactured/fabricated.
(6) When the item is not used with all serial numbers of the same model, the effective
serial numbers are shown on the last line(s) of the description (before UOC).
(7) The usable on code, when applicable (see paragraph 5, Special Information).
(8) In the Special Tools List section, the basis of issue (BOI) appears as the last line(s) in
the entry for each special tool, special TMDE, and other special support equipment.
When density of equipments supported exceeds density spread indicated in the basis
of issue, the total authorization is increased proportionately.
(9) The statement "END OF FIGURE" appears just below the last item description in
Column 5 for a given figure in both Section II and Section III.
(10)The indenture, shown as dots appearing before the repair part, indicates that the item
is a repair part of the next higher assembly.
f.
QTY (Column (6)). The QTY (quantity per figure column) indicates the quantity of the item
used in the breakout shown on the illustration figure, which is prepared for a functional group,
subfunctional group, or an assembly. A "V" appearing in this column in lieu of a quantity indicates
that the quantity is variable and may vary from application to application.
4.
EXPLANATION OF COLUMNS (SECTION IV).
a.
NATIONAL STOCK NUMBER (NSN) INDEX.
(1) STOCK NUMBER column. This column lists the NSN by National item identification
number
(NIIN) sequence. The NIIN consists of the last nine digits of the
NSN
NSN, i.e. (5305-01-574-1467).
NIIN
When using this column to locate an item, ignore the first 4 digits of the NSN.
However, the complete NSN should be used when ordering items by stock number.
(2) FIG. column. This column lists the number of the figure where the item is
identified/located. The figures are in numerical order in Section II and Section III.
F-6
|
