|
| |
TM 5-4930-234-13&P
field operating conditions. This time includes preparation time (including any necessary disassembly/assembly time),
troubleshooting/fault isolation time, and quality assurance/ quality control time in addition to the time required to perform
the specific tasks identified for the maintenance functions authorized in the maintenance allocation chart. The symbol
designations for the various maintenance categories are as follows:
C......................................................................................
Operator or Crew
0 ......................................................................................
Organizational Maintenance
F ......................................................................................
Direct Support Maintenance
H......................................................................................
General Support Maintenance
L ......................................................................................
Specialized Repair Activity (SRA)
D......................................................................................
Depot Maintenance
e.
Column (5) Tools and Equipment. Column 5 specifies, by code, those common tool sets (not individual
tools), and special tools, TMDE, and support equipment required to perform the designated function.
f.
Column (6) Remarks. This column shall, when applicable, contain a letter code, in alphabetic order, which
shall be keyed to the remarks contained in Section IV.
B-4.
EXPLANATION OF COLUMNS IN TOOL AND TEST EQUIPMENT REQUIREMENTS, SECTION III.
a.
Column (1) Reference Code. The tool and test equipment reference code correlates with a code used in
the MAC, Section II, Column 5.
b.
Column (2) Maintenance Catagory. The lowest category of maintenance authorized to use the tool or test
equipment.
c.
Column (3) Nomenclature. Name or identification of the tool or test equipment.
d.
Column (4) National Stock Number. The National stock number of the tool or test equipment.
e.
Column (5) - Tool Number. The manufacturer’s part number.
B-5.
EXPLANATION OF COLUMNS IN RMARKS, SECTION IV.
a.
Column (1) - Reference Code. The code recorded in column 6, Section II.
b.
Column (2) Remarks. This column lists information pertinent to the maintenance function being performed
as indicated in the MAC, Section II.
B-3
|
