|
| |
TM 5-4320-313-14
(4) Remove depth gauge (1).
(5) Install new (4, figure 5-20), shims (5), spring (6), and protection tubes (3).
NOTE
Complete pushrod (2) belongs to injection pump side of engine.
(6) Install pushrods (2 and 1).
(7) Install new gasket (2, figure 5-19) and cylinder head (1) onto cylinder.
(8) Install two air shields (8 and 7, figure 5-18), fuel tank bracket (6), and lifting eye (5).
NOTE
Install rocker shaft with high side up.
(9) Install deflector (4) and rocker shaft (3) with rockers, two air shields, fuel tank bracket, and lifting eye.
(10)Install four flat washers (2) and four nuts (1) on studs and tighten nuts equally and crosswise to a torque of
25.80 ft-lbs (35 Nm).
Figure 5-21. Cylinder Head and Piston Bumping Clearance Measurement.
5-33
|
