|
| |
TM 5-4320-313-14
5-8. CRANKING GEARS - Continued.
a. Removal. (Refer to figure 5-14).
(1) Remove four screws (1) and remove housing (2).
(2) Remove and discard gasket (3).
(3) Remove needle bearing (4), oil seal (5), gear wheel (6), and pin (7) as an assembly.
(4) Remove needle bearing (4), oil seal (5), and pin (7) from gear wheel (6) Discard oil seal (5).
(5) Remove bushing (8) and disc (9).
(6) Remove nut (10) and washer (11).
(7) Remove pinion (12) with puller.
Figure 5-14. Cranking Cover and Gears Removal.
b. Cleaning.
Do not breathe cleaning solvent P-D-680 vapors for long periods of time or use solvent near open
flames. To avoid illness, explosion, or fire, only use solvent in well-ventilated areas away from open
flames.
(1) Clean housing, gear, and pinion with cleaning solvent and rags.
(2) Allow parts to dry.
5-26
|
