|
| |
TM 5-4320-313-14
5-7. FUEL INJECTION PUMP - Continued.
d. Adjustment - Continued.
(4) Refer to figure 5-9 and insert washer (3) and valve body (5) into spill device (1, figure 5-10).
(5) Thread spill device into injection pump and adjust with spill pipe in up position, and then secure in place.
(6) Install dial gauge (2, figure 5-10) with adapter pin 2.68-inch (68 mm) long attached, into spill device, and pre-
tension approximately 1 mm (one rotation of dial indicator hand).
(7) Remove fuel shutoff clamp from fuel hose.
NOTE
Fuel emerging from the spill pipe on spill device must be bubble free.
(8) Move the throttle hand lever to the HIGH position.
Figure 5-10. Spill Device and Dial Gauge Installation.
5-20
|
