|
| |
TM 5-4320-313-14
4-17. THROTTLE - Continued.
b. Installation - Continued.
(7) Install nuts (5 and 6), if they were removed from adjusting screw (10).
(8) Install angular joints (7 and 9) on adjusting screw (10).
(9) Install angular joint (9) on lever (18). Secure with nut (8).
(10) Install angular joint (7) on lever (4). Secure with nut (3).
(11) Tighten nuts (5 and 6).
(12) Install lever (4) on engine. Secure with disc (2) and nut (1).
c. Adjustment. (Refer to figure 4-10).
(1) Idle Adjustment. With engine running, loosen screw (20) and slide fixing flap (23) toward
fuel lift pump side of engine. Move hand lever (17) to desired idle speed. Slide fixing
flap (23) against hand lever (17) and tighten screw (20).
(2) Top Speed Adjustment. With engine running, loosen second screw (20) located closest
to injection pump. Slide second fixing flap (23) toward injection pump side of engine.
Move hand lever (17) to engine top speed. Slide fixing flap (23) against hand lever (17)
and tighten screw (20).
(3) If idle or top speed of engine cannot be obtained, loosen nuts (5 and 6) and turn
adjusting screw (10) to increase or decrease travel of hand lever (17). Tighten nuts (5
and 6) after adjusting.
4-26
|
