|
| |
TM 5-4320-313-14
Section III. SERVICE UPON RECEIPT OF EQUIPMENT
4-5.
SERVICE UPON RECEIPT OF MATERIEL.
a. Inspection. Inspect the equipment for damage and loose or missing components. Report all discrepancies in accordance
with the instructions of DA PAM 738-750.
b. Servicing. Refer to table 2-2 and table 4-1 and perform both the operator and unit preventive maintenance checks and
services.
Section IV. PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)
4-6.
UNIT PMCS. (Refer to table 4-1).
Table 4-1. Unit Monthly Preventive Maintenance Checks and Services
ITEM
ITEM TO BE
PROCEDURE
NO.
INSPECTED
1 Pumping Assembly
Check that pump housing mounting screws are not loose or
missing. Tighten loose screws, report missing screws to direct
support maintenance.
Check that pump housing fill and drain plugs are securely installed
in housing.
Inspect pump housing for cracks. Notify direct support
maintenance if housing is cracked.
2 Engine Oil Level
Check engine oil level. If oil level is below top mark on dipstick, add
oil (item 6, appendix E) to bring oil level to top mark on dipstick.
3 Engine Fuel Hoses
Inspect fuel system hoses and fittings for leaks.
and Fittings
4 Fuel Tank
Inspect fuel tank for secure mounting, cracks, or missing cap.
5 Muffler
Inspect muffler for holes and missing or damaged heat shield or
carbon buildup.
NOTE
Service muffler/spark arrestor every 250 hours of use.
6 Air Filter
Inspect air filter for damage to rain hood.
Change 1 4-3
|
