| |
TM 5-4320-313-14
c. Inspection.
(1) Inspect cover for cracks or signs of wear.
(2) Replace a damaged cover.
d. Installation.
(1) Install auxiliary bushing on crankshaft.
(2) Install new seal (5) into cover (3). Fill groove of oil seal (5) with grease.
(3) Lubricate new packing (4) with grease and install packing (4) in groove of cover (3).
(4) Install cover (3) on crankshaft and secure with two plates (2) and four screws (1). Remove auxiliary bushing and
bend tabs of plates (2) over screws (1).
(5) Torque screws (1) to 7.3 ft-lbs (10 Nm).
(6) Refer to paragraph 5-12 and install flywheel.
Figure 6-11. Oil Seal (Flywheel Side) Removal/Installation.
6-19
|