|
| |
TM 5-4320-306-24
2-18. REPLACE/REPAIR SUCTION ASSEMBLY, STRAINER ASSEMBLY, AND GATE VALVE
This task covers:
a.
Removal
b.
Disassembly
c.
Cleaning/Inspection/Repair
d.
Assembly
e.
Installation
INITIAL SETUP
Tools
Equipment
Condition
Shop equipment, automotive maintenance
Para
Condition Description
and repair, common no. 1
2-16
Control panel cover assembly, con-
Tool kit, general mechanics automotive
trol panel assembly, and control
panel base plate removed.
Materials/Parts
Special Environmental Conditions
Crocus abrasive cloth (Item 1, Appendix C)
Well-ventilated area required for cleaning.
Dry cleaning solvent (Item 17, Appendix C)
REMOVAL:
WARNING
Death or serious injury could occur if unauthorized or unnecessary personnel are in the hoisting
area. Permit only personnel actually engaged in the hoisting operation to be near the unit and
hoisting equipment. All instructions for the hoisting operations must come from one authorized
person.
Injury to personnel or damage to equipment could occur from improper hoisting. Hoist the load
slowly to avoid tearing out lifting bail assembly, slipping slings, or load shift. Do not jerk the load
or swing it from side-to-side when hoisting. This places additional stress on hoisting components
which can cause failure and loss of load. Be sure hoisting equipment is on solid footing and is
suitable for the size of the load. Watch boom angle and overhead clearance when hoisting.
1
Position a suitable lifting device (1) equipped with a spreader bar and slings over suction assembly (2).
2
Attach slings around assembly and put tension on slings. Make sure assembly is properly supported. Spread
slings on spreader bar so that slings hang vertically when attached to assembly.
2-66
|
