| |
TM 5-4320-306-24
4-4. REPAIR INJECTION PUMP (Continued)
18 Press new oil seal (83) into bearing cap (81)
19 Press bearing cup (84) into bearing cap (81)
20 Place intermediate ring (91) and shims (90) onto governor end of camshaft (82)
CAUTION
Press only on the inner race of bearing cone during installation to prevent damage to bearing.
21 Press bearing cone (89) onto camshaft (82)
22 Place intermediate ring (88) and shims (87) onto drive end of camshaft (82)
CAUTION
Press only on inner race of bearing cone during installation to prevent damage to bearing.
23 Press bearing cone (86) onto camshaft (82)
24 Apply a thin film of MolyKote paste to surface of bearing support (85) Install bearing support onto camshaft (82)
25 Press bearing cap (81) onto camshaft (82).
4-23
|