|
| |
TM 5-4320-306-24
Section II. MAINTENANCE PROCEDURES
INDEX
Para
Para
Camshaft
4-8
Cylinder head assembly and rocker arms
4-6
Connecting rod assembly
4-11
Fuel injectors
4-5
Crankcase assembly
4-13
Injection pump
4-4
Crankshaft assembly
4-12
Piston assembly
4-10
Cylinder assembly
4-9
Valves, valve guides, and valve seats
4-7
INDEX
4-3. GENERAL INSTRUCTIONS
Most maintenance instructions in this section will list resources required, personnel required, and equipment condition for
the start of the procedure. Note the following.
*
Resources required are not listed unless they apply to the procedure.
*
Personnel required are listed only if the task requires more than one. If PERSONNEL is not listed, it means one
person can do the task.
*
The normal standard equipment condition to start a maintenance task is engine stopped and START/STOP
switch set at STOP. EQUIPMENT CONDITION is not listed unless some other condition is required besides the
power being off.
*
Refer to Appendix D to determine torque requirements when tightening threaded fasteners, unless a specific
torque value is given in the procedure. Standard torque values given in Appendix D are determined by thread
size.
4-4
|
