|
| |
TM 5-4320-306-24
3-19. REPLACE CYLINDER HEAD ASSEMBLY, ROCKER ARMS, PUSHRODS, AND TAPPETS (Continued)
2.
Mount cylinder head (3) and intermediate ring (4) on cylinder
3.
Insert waisted bolts (5) and washers (6) in cylinder head (3).
4.
Pretighten waisted bolts (5) alternately and evenly across cylinder head (3) with socket spanner No
120040/120050 (7) to 29.50 ft-lb (40 N.m) torque Using torque gage No. 101900 (8), tighten each bolt (5),
crosswise, three additional 45 degree increments, then, maintaining crosswise pattern, tighten each bolt an
additional 30 degrees.
5.
Rotate crankshaft two complete revolutions of 360 degrees.
6.
Remove waisted bolts (5) and washers (6). Mark and remove cylinder head(s) (3) and inter- mediate rings (4)
3-105
|
