|
| |
TM 5-4320-306-24
3-6. REPLACE ENGINE ASSEMBLY (Continued)
2.
Place sling under crankcase at blower end of engine assembly.
3.
Put tension on sling and position spreader bar so that sling hangs vertically and does not crush components mounted
on engine Make sure engine is properly supported.
4.
Apply only enough lifting force to remove pressure from support bracket (3) and rear engine supports (4).
5.
Remove bolts (5), washers (6), lockwashers (7), nuts (8), bolts (9), and nuts (10) from engine supports (4). Remove
engine supports from support bracket (3) and from the skid.
3-21
|
